Rigidity-First Orientation
G10 Epoxy Prepreg reinforces epoxy with fiberglass cloth in B-stage semi-cured state, hot pressing into a high-strength rigid insulating board-like part. Its orientation runs to mechanical support and structural reinforcement, for insulation pieces that must take clamping, bending, and vibration at the same time. Against grades focused on electrical heat resistance, this one puts the cloth's skeleton strength first; the cured part stays firm and non-deforming for support bars, partitions, and end fixtures. The buyer cuts and stacks, hot presses in their own mold, and resin fills cloth gaps into a dense rigid body that does not collapse under long pressure.
B-Stock Cut and Burr-Free Edge
The cloth skeleton gives the cured piece enough stiffness for long support without settling, suitable between coil and clamp as a pressure pad that soft material would deform over years. B-stage state cuts cleanly; resin flows into fiber gaps on heating and cures into a dense interior with neat, burr-free edges. Cure 150-170°C, 35MPa, 30 to 60 minutes, with hold advice from the plant by part thickness and shape for the buyer's press.
Support Bars and Partitions
This G10 Epoxy Prepreg forms transformer coil support bars and rigid partitions under clamp force, motor end-winding fixtures that hold shape against vibration loose, insulation pads between metal clamps and live parts that crack under pressure, and other rigid insulation skeletons molded to the customer die.
Blank Supply
Wenzhou Gisen Insulation Material Co.,Ltd holds ISO9001, checking resin state, appearance, and insulation per batch with tensile and breakdown testers, accepting third-party inspection. Where support bars and partitions carry clamp load year-round, the rigid cured body resists the slow settling that soft pads show over time; sheets cut to drawings or supplied as stamping blanks, with rigidity and size confirmed at proofing before the customer presses the finished part in its own mold. MOQ 500kg; free samples; custom samples 2 weeks, standard 3-4 weeks, custom 4-6 weeks; EXW/FOB; custom 50%/50%; RMB or USD; packaging per request.
Specification Parameters
|
Parameter |
Specification |
|
Base |
Fiberglass cloth reinforced epoxy |
|
Resin state |
B-stage semi-cured |
|
Cure condition |
150-170°C, 35MPa, 30~60 minutes |
|
Temperature class |
H-class (180°C) ~ C-class (220°C) |
|
Processing |
Cut to size or stamping blank |
Hot Tags: g10 epoxy prepreg, China g10 epoxy prepreg manufacturers, suppliers, factory, electrical grade mesh, epoxy prepreg roll, fiberglass fabric prepreg, fibre reinforced prepreg, prepreg sheet, reinforced fiberglass prepreg

